Installing The Side Cover - IBM 4348 Installation Manual

2. Push the bottom of the bezel toward the server until the bezel snaps into place.

Installing the side cover

Note: You might find it easier to lay the server on its side to replace the side cover.
To replace the side cover, complete the following steps:
1. Make sure that all cables, adapters, and other components are installed and
2. Align the cover over the server (with the rear of the cover slightly hanging off
26
System x3100 Type 4348: Installation Guide
Bezel
retention
slots
Bezel
alignment
tabs
seated correctly and that you have not left loose tools or parts inside the server.
the rear of the server) and slide the cover toward the front of the server until it
is completely closed.