Installing The Side Cover - IBM System x3200 Problem Determination And Service Manual

Installing the side cover

Attention:
on the server. Operating the server for extended periods of time (more than 30
minutes) with the side cover removed might damage server components.
To install the side cover, complete the following steps.
1. Make sure that all cables, adapters, and other components are installed and
2. If you removed the upper and lower bezels, reinstall them before you replace
3. Position the lip on the bottom edge of the side cover on the ledge on the bottom
4. Lock the side cover.
5. Reconnect the external cables and power cords; then, turn on the attached
78
System x3200 Types 4362 and 4363: Problem Determination and Service Guide
For proper cooling and airflow, replace the side cover before you turn
seated correctly and that you have not left loose tools or parts inside the server.
Also, make sure that all internal cables are correctly routed.
the side cover (see "Installing the upper bezel" on page 82 and "Installing the
lower bezel" on page 80).
Important: The cover lock must be in the unlocked (opened) position before
you install the side cover.
of the chassis; then, tilt the top of the cover into position on the chassis until it
latches securely into place.
devices and turn on the server.