Installing Or Replacing The Secondary Hard Disk Drive; Installing The Secondary Hard Disk Drive - Lenovo 10A4 Hardware Maintenance Manual

Figure 170. Installing the primary hard disk drive
11. Connect the signal cable and the power cable to the new primary hard disk drive.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 224.

Installing or replacing the secondary hard disk drive

This section provides instructions on how to install or replace the secondary hard disk drive.
Note: The secondary hard disk drive is only available in some models.

Installing the secondary hard disk drive

Attention: Do not open your computer or attempt any repair before reading and understanding the Chapter
1 "Safety information" on page 1.
To install the secondary hard disk drive, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Remove the computer cover. See "Removing the computer cover" on page 153.
3. Remove the front bezel. See "Removing and reinstalling the front bezel" on page 154
4. Press the retaining clip
same time.
196
ThinkCentre M83 and M93/p Hardware Maintenance Manual
1 in the direction as shown and pivot the drive bay assembly upward at the