Pace TDC776D Operator's Manual page 35

If you have not done so, put your set-top into "user settings mode", as described on page 21.
The flow diagram on the right shows how you use the arrow, SELECT and POWER buttons on
your set-top's front panel to change the display and make the settings. See also the instructions below.
1. Press the D button until the front panel shows "reSt" (short for "restore factory settings"), as
shown right.
2. Press the R button. "YeS" appears on your set-top's front panel. (If you no longer wish to restore
the factory settings, press the L button.)
You may also see this message on your TV screen: "Restore Default. Press OK to confirm"
3. To confirm and restore the factory settings, press the SELECT button.
The factory settings are restored, and the PACE USER SETTINGS menu reappears.
4. If you want to continue changing the settings, see the sections from page 21 onwards. If you have
finished changing the settings, press the POWER button. Your set-top will switch on with the
restored settings.
If your set-top and HDTV are connected via a standard HDMI
about the required settings back to your set-top (see page 23). If you wish to restore your set-top's
settings to those created by your HDTV, you should disconnect your set-top from your HDTV before
you restore the factory default settings. When you reconnect your HDTV to your set-top via the HDMI
cable, your HDTV will pass back the information again.
Always turn off your set-top, wait 60 seconds, then disconnect your set-top from the wall AC
outlet before you connect or disconnect any other equipment to or from its rear panel.
NOTES
TM cable, your HDTV may pass information
MAKING USER SETTINGS (cont.)
SELECT
TM
SELECT
SELECT
33