Pace TDC776D Operator's Manual page 26

MAKING USER SETTINGS (cont.)
Changing the TV Display Capability
If you have not done so already, put your set-top into "user settings mode", as described on page 21.
Press the U or D button until the front panel shows "reS" (short for "resolution").
The flow diagram on page 25 shows how you use the arrow and SELECT buttons on your set-top's
front panel to change the display and make the settings. See also the instructions below. The available
resolutions are: 1080i, 720p, 480p and 480i. (See pages 23 and 25 for more information about these.)
1. To change the TV Display Capability, press the R button when you see "reS" on the front
panel, as shown right.
The front panel shows the TV display capability that was last selected, so it could show 480i, 480P,
720P or 1080i (this final setting is displayed as 1080). You will probably also see the TV Display
Capability menu, shown right, on your TV screen. If you cannot see this menu, you should be able
to do so by the time you have finished making these Display Capability settings.
2. If you can see the menu, proceed as follows:
Press the U or D button to highlight each resolution in turn and, for each one, press the
SELECT button if you wish to change the setting (the setting changes between "YES" and
"NO" each time you press SELECT). If, at any stage in this process, the menu disappears from the
screen, immediately press SELECT to restore the menu.
3 If you press the R button when you see "reS" on the front panel, but the menu does not appear
on your TV screen, proceed as follows:
Press U or D until "1080" is displayed on the front panel, then press SELECT.
If the menu then appears, check and change the settings as described in Step 2 above.
If the menu does not appear at this stage, press SELECT again, then press U or D until "720P" is
displayed on the front panel, and then press SELECT. If the menu then appears, check and change
24 the settings as described in Step 2 above. Repeat this process until you have tried all the resolutions.
If the displayed resolution is
currently set, the MESSAGE light
will be lighted and YES will be in
the menu
TV Display Capability
1080i : YES
720p : NO
480p : YES
480i : YES