Changing Hdmi Settings; Removing The User Settings Menus - Pace TDC776D Operator's Manual

Changing HDMI Settings

You can use the HDMI Settings menu to choose an Audio Output Mode, and to enable or disable
automatic detection of a newly connected HDTV (when using an HDMI
1. If you have not done so already, put your set-top into "user settings mode", as described on page
21. Then press the U or D button until the front panel shows "hdni", as shown right.
2. Press the R button. The HDMI Settings menu, shown right, appears.
3. Press the U or D button to highlight "Audio Output Mode" or "Disable Auto Detect" as
required.
4. Use the SELECT button to choose the setting you want (the setting changes each time you
press SELECT):
Audio Output Mode has three possible settings:
"Auto" (provides the audio format best suited to the connected equipment)
"LPCn" (provides PCM audio only)
"PASS" (maintains the original incoming-audio format)
Disable Auto Detect is either "YeS" or "no".
5. When you have made all the changes you want to make, press L to re-display the PACE USER
SETTINGS menu.

Removing the User Settings menus

When you have finished making all the user settings you wish to make, press the POWER button
to remove the PACE USER SETTINGS menu and return to normal viewing.
MAKING USER SETTINGS (cont.)
cable).
TM
HDMI Settings
Audio Output Mode : Auto
Disable Auto Detect : NO
31