Olivetti d-Copia 2001 Operator's Manual page 46

USER SETTINGS
Program
Program name
number
25 Key auto repeat
26 Key press time
27 Audible signals volume
Base setting beep
28
signal
29 Number of copies limit
30 Use close paper size
31 Default tray setting
Default exposure
32
mode
USB 2.0 mode
33
switching
34 Sort auto select
1
* When the SPF is installed.
2
* On models with a dual function board.
4
* d-Copia 1601 is as follows:
1: Upper tray (factory default),
2: 250-sheet paper feed unit/Upper paper tray of 2 x 250-sheet paper feed unit,
3: Lower paper tray of 2 x 250-sheet paper feed unit,
5: Bypass tray
42
Setting codes
(factory default setting
appears in bold)
0: OFF
1: ON
1: Minimum
(current response
speed)
2: 0.5 sec.
3: 1.0 sec.
4: 1.5 sec.
5: 2.0 sec.
1: Short beep
2: Long beep
3: OFF
0: OFF
1: ON
1: 99 copies
2: 999 copies
0: OFF
1: ON
1: Upper paper tray
2: Lower paper tray
3: 250-sheet paper
feed unit/
Upper paper tray of 2
*4
x 250-sheet paper
feed unit
4: Lower paper tray of 2
x 250-sheet paper
feed unit
5: Bypass tray
1: AUTO
2: TEXT
3: PHOTO
1: Full-Speed
*2
2: Hi-Speed
1: OFF
*1,*2
2: Sort
3: Group
Explanation
• Use this setting to select whether or not
holding down a key causes repeated input of
the key. For keys that normally cause a set
value to increase when held down (for
example, holding down the [ZOOM] key (
)), this program can be used to have the set
value not change when the key is held down.
• Use this setting to select how long a key must
be pressed for the input to be accepted. By
selecting a longer time, you can prevent
settings from being changed by the accidental
pressing of a key.
• This sets the volume of beep signals. (p.43)
• Use this to sound a beep when a base setting
is selected. (p.43)
• Use this setting to select 99 or 999 for the
maximum number of copies.
• When this function is enabled, printing in
printer mode will automatically continue using
a different size of paper if the specified size of
paper runs out in all trays. This feature does
not function in copy mode.
• Use this program to select a default tray. This
tray is automatically selected each time the
power is turned on or each time the machine
reverts to the initial settings.
• Use this program to set "AUTO", "TEXT", or
"PHOTO" as the default exposure mode.
• This sets the USB 2.0 data transfer speed. To
obtain the fastest speed when using the USB
2.0 connector, first verify that your computer
meets the system requirements (operating
system and driver), and then use this program
to change the USB 2.0 mode to "Hi-Speed".
• Use this setting to select the default output
mode for copying from the SPF.
,