Olivetti Fax_Lab 106 Instructions Manual page 41

CODE OPERATING FUNCTION
1 Plays new messages.
2 Plays all messages.
3 Stops playing current message and returns to
previous message.
4 Stops playing current message and skips to next
message.
5 Playing outgoing message 1.
6 + 6 Deletes all played messages.
CODE PROGRAMMING FUNCTION
# 1 Disables the "TAD/FAX" reception mode and
enables the "AUTOMATIC" reception mode.
# 2 Sets up the fax machine for "TAD/FAX" reception
mode.
# 3 Enables the OUTGOING MESSAGE 1 to be re-
corded.
# 4 Enables the OUTGOING MESSAGE ONLY to be
played.
Typing 0 after an operating sequence from 1 to 6 aborts the
function in progress.
Typing 0 after a programming sequence from #1 to #4 aborts
the programming function in progress and returns to the op-
erating functions. In this case, to resume the programming
phase, press # again.
If any code is typed during the recording of outgoing mes-
sage 1 (programming #3), the TAD will stop immediately and
confirm the recording.
To perform both the remote playback and programming
functions, you must:
• Dial the fax number on the remote telephone. The TAD will
answer the call and play OUTGOING MESSAGE 1.
• Type the access code on the remote telephone keypad.
• If the code is correct, the TAD will confirm the operation by
emitting a beep.
• Choose the function that you want to perform and type its
code with reference to the table above.
The TAD confirms the operation by emitting a beep.
Terminate communication using the method applicable to
the telephone you are using.
S
PECIAL FUNCTIONS OF THE TELEPHONE
ANSWERING DEVICE
You can set up the TAD for the following special functions:
• TOLL SAVER
• OUTGOING MESSAGE ONLY
• SILENT RECEPTION OF INCOMING MESSAGES
T
OLL SAVER
Using this function, when you access the TAD from a
remote location to listen to any messages, the fax ma-
chine will answer as follows:
• if there are no new messages, it will answer the call
two rings after the number preset;
• if there are some new messages, it will answer the
call after the preset number of rings (see "To
change the number of rings", chapter "More so-
phisticated operations").
Therefore, if you hear one ring more than the preset
number, you will know that there are no new mes-
sages and you can hang up before the fax machine
answers the call.
This function may only be enabled by the customer
engineering service and is not available in all coun-
tries.
1. Press the key:
The display shows:
2. Press the keys
until the display shows:
3. Press the key:
The display shows:
4. Press the keys
until the display shows:
5. To confirm the setting, press the key:
The display shows:
6. To view the other available option, "TOLL SAVER -
YES", press the keys:
3 9