Mercedes-Benz ML320 Cdi Operator's Manual page 360

Press button k or j on the
multifunction steering wheel until the
following message appears in the mul-
tifunction display:
One of the following messages will
subsequently appear in the
multifunction display:
Engine oil level OK
Add 1.0 qt. to reach max. oil
level
(Canada: 1.0 liter )
Add 1.5 qts. to reach max. oil
level
(Canada: 1.5 liters )
Add 2.0 qts. to reach max. oil
level
(Canada: 2.0 liters )
i
If you want to interrupt the checking proce-
k j
dure, press the or button on the
multifunction steering wheel.
If necessary, add engine oil
( page 361).
For information on adding engine oil, see
( page 361).
For more information on engine oil, see
"Technical data" section ( page 543) and
( page 546).
Other display messages
If the SmartKey or KEYLESS-GO*
start/stop button is not in position 2, the
following message will appear:
Switch ignition on
to check engine oil level
Switch on the ignition ( page 40).
If you see the message:
Observe waiting period
Engine compartment
If the engine is at operating
temperature, wait 5 minutes before
repeating check procedure.
If the engine is not at operating temper-
ature, wait 30 minutes before repeat-
ing check procedure.
If you see the message:
Engine oil level
Not when engine on
Turn off the engine.
If the engine is at operating tempera-
ture, wait 5 minutes before checking
oil.
If the engine is not at operating temper-
ature yet, you must wait 30 minutes
before checking oil.
If there is excess engine oil with the engine
at operating temperature, the following
message will appear:
Engine oil level
Reduce oil level
Operation
359