Mercedes-Benz ML320 Cdi Operator's Manual page 290

Pulling the partition net tight
Belt hook attached behind the front seats
1 Belt hook
2 Cargo tie-down ring
3 Tightening belt
Hook belt hook 1 into cargo tie-down
ring 2 in direction of arrow.
Pull tightening belt 3 by the loose end
in direction of arrow until the partition
net is pulled tight.
After driving a short distance, make
sure the partition net is still tight and, if
necessary, pull it tight again.
Loosening the partition net
Belt hook attached behind the front seats
1 Buckle
2 Belt hook
3 Cargo tie-down ring
Loosen the tightening belt by pulling
buckle 1 upward in direction of arrow.
Remove belt hook 2 from cargo
tie-down ring 3.
Controls in detail
Removing and storing the partition net
Take partition net bar 2 out of
holder 1, see "Installing the partition
net" ( page 288).
Press the red button on the upper and
lower partition net bar.
Fold the partition net.
Roll up the partition net.
Close the zipper on the partition net
package.
Loading
289