Mercedes-Benz ML320 Cdi Operator's Manual page 193

Controls in detail
Automatic transmission
Rocking the vehicle
Rocking the vehicle by shifting between
drive position D and reverse gear R can
help free a vehicle stuck in mud or snow.
The engine control system of this vehicle
electronically limits shifting between drive
position D and reverse gear R to very low
speeds, i.e. approx. 5 mph (9 km/h). To
shift between drive position D and reverse
gear R, move the gear selector lever past
the resistance point up or down.
Working on the vehicle
Warning!
When working on the vehicle, set the
parking brake and shift to park position P.
Otherwise the vehicle could roll away.
192
Hill start assist system
Warning!
The hill start assist system is not designed
to function as a parking brake and does not
prevent the vehicle from moving when
parked on an incline.
Always set the parking brake in addition to
shifting to park position P.
On uphill grades with a gradient angle of
more than 5°, the hill start assist system
maintains the pressure in the brake sys-
G
tem for approximately 1 second after you
have released the brake pedal. Therefore,
you can start off smoothly without the
vehicle moving immediately after releasing
the brake pedal.
The hill start assist system is inactive
when starting off on a level road or
G
downhill grades
with the transmission in neutral
position N
with the parking brake set
®
if the ESP has switched off due to a
malfunction
Towing a trailer
If you tow a trailer, note the following
points:
Manually shift to a lower gear range
( page 193) if the transmission hunts
between gears on inclines.
A lower gear range and reduction of
speed reduces the chance to overload
or overheat the engine.
For more information on trailer towing, see
the "Operation" section ( page 342).