Breadman TR700SPR Instruction Manual page 13

SUPER RAPID BREAD RECIPES
Method
1. Remove the Bread Pan from the Bread Baker. Attach the Kneading Paddle onto
the Shaft. Have all ingredients ready. Make sure all ingredients, except water, are at
room temperature.
2. Use a liquid measuring cup to measure the water 100˚-115˚F / 43˚-46˚C and pour
into the Bread Pan.
3. Use a measuring spoon to measure the oil and add to the Bread Pan.
4. Use a measuring spoon to measure the sugar, salt and dry milk; level off with the
straight edge of a knife and add to the Bread Pan.
5. Lightly spoon bread flour into a dry measuring cup, level off with the straight edge
of a knife and add to the Bread Pan.
6. Carefully measure Quick-Rise™ yeast with a measuring spoon; level off with the
straight edge of a knife and add to the Bread Pan.
7. Place the Bread Pan into the Bread Baker. Push down on the Rim until it snaps
into place. Close the Lid and plug in the Breadman
8. Select Super Rapid Cycle and press START.
9. At the beep during the Kneading Cycle, (:53), check the dough ball. It should be
sticky to the touch. At this time, push down any dough or flour that may be on the
sides of the Pan.
10. When the Beeper sounds, the bread has finished baking.
11. Use oven mitts to carefully remove the Bread Pan.
CAUTION: The Oven Cavity, Bread Pan, Kneading Paddle and bread will be very
hot. Use oven mitts.
12. Turn Bread Pan upside down and shake several times to release the bread.
Do not use metal utensils inside the Bread Pan or Bread Baker. Remove the
Kneading Paddle and allow loaf to cool standing upright on wire rack
approximately 20 minutes before cutting.
13. When the bread has completely cooled, approximately 2 hours, store in an air-
tight container.
14. Unplug unit before cleaning. Do not immerse the Bread Pan in water.
See Cleaning Instructions.
(continued)
.
®
11