When The Water System Is Started For The First Time - Electrolux ERES31800 Instruction Book

Cabinet is placed at a location where
the ambient temperature corresponds
to the climate classification*, for which
the appliance is designed.
* See on the rating plate on the inside
of the appliance.
The following table shows which
ambient temperature is correct for
each climate classification.
Climate
classifi-
cation
SN +10°C to +32°C
N
+16°C to +32°C
+18°C to +38°C
ST
T
+18°C to +43°C
If the cabinet is placed in a corner and
the side with the hinges facing the
wall, the distance between the wall
and the cabinet must be at least 230
mm to allow the door to open enough
so that the shelves can be removed.
Check that the drain hose at the rear
of the cabinet discharges into the drip
tray.
The power plug must be accessible
after installation of the cabinet.
When the water system is started for
the first time.
The following should be carried out
when the refrigerator is correctly
connected to the water supply in the
building:
Open the tap on the water connection
and start up the refrigerator. The water
system main valve opens and the
system starts to fill up. Wait for five
minutes.
23
for an ambient
temperature of
Unpack the filter provided and connect
it as follows:
- Remove the filter protective cap and
insert the filter connector into the filter
seat and turn as shown in the
illustration (2) until the filter engages
and the projection on the filter
cartridge is opposite the mark on the
plastic cover. See also the illustration
and the instructions on the inside of
the service hatch.
1
- Unlock the water dispenser. See the
section "The water dispenser
functions" Select carbonated water
and drain off about 1.5 litres (2.5 pints)
of water. There may be some air to
start with.
Connect the gas cylinder provided as
follows:
- Take out the gas cylinder from plastic
bag and screw the gas cylinder into
the adapter (3) for this purpose, which
is located in the cabinet, doing this by
hand without tools.
2