Blackout Mode On And Off; Switching The Display Modes; Setting The Dhe/Eq For Each Music Source - Alpine CDA-7878R Owner's Manual

Basic Operation
TUNE
g DN
f UP

Blackout Mode On and Off

When the Blackout mode is turned on, the display
will turn off to reduce power consumption.
This additional power enhances the sound quality.
1
Press and hold the B.OUT button for at least 2
seconds to start the blackout mode. By doing so
the display will turn off.
NOTE
If any button on the unit is pressed during the blackout
mode, the function will be displayed for 5 seconds to
show the operation before returning to Blackout mode.
To cancel the blackout mode, press and hold the
B.OUT button for at least 2 seconds.

Switching the Display Modes

You can select the display pattern mode from
three display patterns. You can also deactivate the
display.
1
Press the DISP (DISPLAY) button to select the
desired Display pattern mode.
Each press changes the display patterns.
→ Pattern1 → Pattern2 → Pattern3 → Display OFF
Setting the DHE/EQ for each Music
Source
You can set the DHE/EQ independently for each
music source (e.g., radio, CD, MP3, etc.).
1
Press and hold the SETUP button for at least 2
seconds.
10
-EN
DISP/B.OUT T.S.M.
TITLE SETUP
2
3
4
Press the f UP button repeatedly to select
"SRC DHE."
Each press of the f UP button changes the
modes as shown:
↔ ↔
FM-LEVEL REGIONAL PI SEEK
DEMO
CONTRAST
AUX
MUTE
↔ ↔
SCROLL DISC/FOLDER
BEEP
∗ Displayed when you set SUB-W to ON.
NOTE
If you press the g DN button, the display scrolls in
reverse sequence.
Press the TUNE button to toggle the mode
between SRC DHE ON and SRC DHE OFF.
SRC DHE ON:
You can set the DHE/EQ independently for each
music source (e.g., radio, CD, MP3, etc.).
SRC DHE OFF:
You can set the same DHE/EQ for all the music
sources at the same time.
NOTE
The initial setting at the factory is SRC DHE OFF.
Press the SETUP button to set the selected
mode.
↔ ↔
TUNER SUB-W
SUB-W
(switching phase) ∗
SUB-W
STEREO/MONO ∗
↔
SRC DHE