Table of Contents
Advertisement
ProSafe Dual Band Wireless Access Point WNDAP330 Reference Manual
Configuring the WNDAP330 as a Wireless Repeater
To configure the WNDAP330 as a Wireless Repeater as shown in
1. Under the Configuration tab, select Wireless Bridge on the main menu. Then, select Bridging
and Repeating. The Bridging and Repeating screen will display.
2. Configure the Operating Mode of the WNDAP330 Wireless Access Points.
•
WNDAP330 (AP1) on LAN Segment 1 in Repeater mode with the Remote MAC Address
of AP2.
•
Configure WNDAP330 (AP2) in Repeater mode with MAC addresses of AP1 and AP3.
•
Configure the WNDAP330 (AP3) in Repeater mode with the Remote MAC Address of
AP2.
Figure 4-10
3. Verify the following parameters for all access points:
•
Verify that the LAN network configuration the WNDAP330 Wireless Access Points are
configured to operate in the same LAN network address range as the LAN devices.
•
All access points must be on the same LAN. That is, all the LAN IP addresses of the
access points must be in the same network.
4-18
v1.0, May 2008
Figure
4-10:
Advanced Configuration
Advertisement
Table of Contents
