Loading Paper Into The Multi-Bypass - Olivetti d-Copia 15 Operation Manual

5
Set the paper flush against the left-hand wall of the drawer.
IMPORTANT
* There is a sticker ("1" in the illustration) indicating paper capacity
attached to the inside of the drawer. Do not load paper above this
limit.
* When loading paper into the drawer, make sure that the copy side is
facing upward. (The copy side is the side facing upward when the
package is opened.)
* Check that the length adjustment plate and width guide make
secure contact with the paper. If there is a gap, adjust the position of
the length adjustment plate or width guide.
6
Set the supplied paper size sheet so that the size of the
paper loaded can be checked by looking at the front of the
drawer.
CHAPTER 3 PREPARATIONS BEFORE USE
7
Gently push the drawer back in.
* Check that the paper is kept under the claws of the drawer.
If not, reload the paper.
* Before leaving the copier in disuse for a prolonged period
of time, remove the paper from the drawer(s) and seal it in
its original packaging to protect from moisture.

(3) Loading paper into the multi-bypass

Special paper as well as standard paper can be loaded into the multi-
bypass. When copying onto special paper, be sure to use the multi-
bypass.
* The number of sheets of standard paper, colored paper and
letterheads that can be loaded into the multi-bypass differ depend-
ing on the paper size.
11" x 17" and 8 1/2" x 14" (A3, B4 and Folio): 25 sheets
11" x 8 1/2" and 5 1/2" x 8 1/2" (A4 to A5 [vertical]): 50 sheets
* The types of special paper and the number of sheets that can be
loaded in the multi-bypass are:
• Transparencies: 1 sheet
2
• Standard paper (120g/m , 160g/m
1
Open the multi-bypass.
2
): 1 sheet
3-2