Smdr Call Report - Lucent Technologies SPIRIT 2448 Administration Manual

SMDR Call Report

DAY OF WEEK
Press FEATURE. Dial 1.
Line indicator lights will be OFF. Enter a digit from 1-7 (1 is Sunday, 2 is Monday, etc.).
You will hear a confirmation tone if you enter a valid digit and an error tone if the digit you
entered is not valid. The information will be used as part of the call record. If the day of the
week is not entered, ? will appear on the call record.
A System Reset (see page 14) will not affect the day of week setting.
TIME OF DAY
Press FEATURE. Dial 2.
Line indicator lights will be OFF. Enter a four-digit time in 24-hour format (for example, if the
time is 2:15 in the afternoon, enter 1415). Valid times are 0000 to 2359. You will hear a
confirmation tone if you enter a valid time and an error tone if you enter an invalid time.
The time is set at 9999 when shipped from the factory and will not change until a time is
entered. If you reset the system (see page 14), the TIME OF DAY setting will not be affected.
REPORTED CALL DURATION
Press FEATURE. Dial 3.
Line indicator lights will be OFF. Enter a digit from 1 to 9 to indicate the minimum length of
call to be reported. If a 1 is entered, the system will report any call longer than 10 seconds.
If a 2 is entered, the system will wait for 20 seconds before reporting the call, and so on.
Maximum entry is 9, for ninety seconds. You will hear a confirmation tone after entering a valid
digit, and an error tone after an invalid entry. Installed setting is 30 seconds.
INCOMING CALL REPORT
Press FEATURE. Dial 4.
Line 1 indicator light shows the current setting for incoming call reporting on a system-wide
basis. Outgoing calls are always reported. Enter a 1 to prevent incoming calls from being
reported. Enter a 2 to report incoming calls.
DIAL
1
2
After customizing a feature, you may do any of the following:
press the FEATURE button to customize another feature
press the ENTER ADMIN button to go back to STEP 5 on page 13
hang up the receiver or press SPEAKER to exit customization
26 Administration Manual
INDICATOR LIGHT
OFF
ON
SETTING
Incoming Calls Not Reported Disabled
Incoming Calls Reported Enabled (installed)