Connecting The Spirit Attendant; Setup Switch Positions For Installing Unit - AT&T SPIRIT Attendant Installer's Manual

Connecting the SPIRIT Attendant

CAUTION: Before initial installation of the SPIRIT Attendant, set
switches 1 and 2 on the back panel to off (up).
Follow the steps below to install the SPIRIT Attendant:
FIGURE 1-3. Setup Switch Positions for Installing Unit.
1. For each SPIRIT Attendant port:
a. Install a SPIRIT Attendant ConnecT/R (118B) on the SPIRIT system
control unit.
2. Place the SPIRIT Attendant on a table or desktop, or mount it using the
mounting bracket:
a. Using a #10 or smaller screw (wood, sheet metal, concrete), attach the
wall mounting bracket to a vertical wall surface so that the hook end
of the bracket is down.
b. Locate the keyhole opening on the underside of the SPIRIT Attendant
with the hook on the bracket. Slide the unit over the hook and down
to secure.
CAUTION: Do not stack multiple SPIRIT Attendants; this will damage
the units.
3. Make sure setup switches 1 and 2 are off, then plug one end of the modular
phone cord into the jack on the back of the SPIRIT Attendant labeled "to
line." (See Figure 1-3.)
4. Plug the other end of the modular phone cord into the 118B jack labeled
"TEL DEVICE." (See Figure 1-4.)
1-9
Installation Requirements