Programming Codes For Assigning Buttons - Lucent Technologies MERLIN LEGEND Release 6.1 System Programming Manual

MERLIN LEGEND Communications System Release 6.1
System Programming Guide 555-661-111
3 Programming Procedures
Extensions
Table 3–6
You can handle errors in data entry as follows:
If you enter a feature code incorrectly while programming, the display
shows the
button flashes. If this happens, press the button again and repeat the
procedure.
If you make a mistake and program the wrong feature on a button, press
the button, select
Table 3–6.
Use
To assign SA or ICOM
Ring button
To assign SA or ICOM
Voice button
To assign SA or ICOM
Originate Only Ring button
To assign SA or ICOM
Originate Only Voice
button
To assign SA button
To change current
assignment for SA or
ICOM Voice, Originate
Only or Shared SA buttons
from Voice to Ring
provides the programming codes for assigning Ring and Voice buttons.

Programming Codes for Assigning Buttons

On the Console
Dial
Dial
being programmed
again, and dia
Dial
Dial
being programmed
again, and dial 
Dial
extension number of
principal telephone
[nnnn] then press the
button number being
shared [nn]
Dial
message and the red LED next to the
( on the PC), and press the button again
, press button
l
, press button
press the
,
Issue 1
August 1998
Page 3-282
On the PC
Type
, press
function key for button
being programmed
again, and type
Type
Type press
,
function key for button
being programmed
again, and type
, press the
Type
extension number of
principal telephone
[nnnn] then press the
button number of
specific button being
shared [nn]
Type
+
+