AT&T MERLIN 1030 Planning Manual page 14

Administrator/Attendant Consoles for
Large Systems* in Administration Mode
1.
T/P switch: Set to P when performing system administration
2 .
Adm Tel button: Used when assigning lines to voice terminals
and asslgnlng voice terminals Dial Access to Line Pools.
3.
Adm Pool button: Used when setting up line pools.
4.
Line buttons and programmable buttons: Buttons in first two
left-hand columns are always line buttons.
5.
Auto Intercom buttons (10 through 79).
6.
Auto Intercom buttons: Buttons in this column represent in-
tercom numbers 10-19,40-49, or 70-79, depending on which Shift
button you touch.
7.
Auto lntercom buttons: Buttons in this column represent in-
tercom numbers 20-29 or 50-59, depending on which Shift but-
ton you touch.
8.
Auto Intercom buttons: Buttons in this column represent in-
tercom numbers 30-39 or 60-69, depending on which Shift but-
ton you touch.
9.
Shift button: Used to access Auto Intercom buttons for inter-
com numbers 10 through 39.
10.
Shift button: Used to access Auto Intercom buttons for inter-
com numbers 40 through 69.
11.
Shift button: Used to access Auto Intercom buttons for inter-
com numbers 70 through 79.
12.
Message Status button: Not used for system administration.
13.
Adm Misc button: Used when administering allowed-list call
14.
Call Rstr button: Used when setting lines to detect a toll prefix
or area code only and when assigning outward and toll call
restrictions to voice terminals.
15.
Message button: Used when giving a voice terminal the same
assignments as one that has already been administered.
16.
Conference button: Used when assigning features to individual
voice terminals from this console.
*
Systems with more than 8 lines or more than 20 voice terminals—
switch H on control unit is down.
13