Table of Contents
Advertisement
12. INSTALLATION
OF Ol?TIONAL
PARTS
Battery mount kit
1. Remove and retain the two bolts attaching
the upper frame to the lower
frame on the generator side. Position the battery guards on the lower frame
and install using the bolts retained. (See page 39)
2. Position the battery tray on the battery guards and install with the attach-
ing hardware shown.
3. Pass the starter cable between the control box and generator and connect to
the outer terminal of the starter magnetic relay.
4. Attach
the ground cable to the frame at the upper left of the generator as
shown. Tighten securely.
5. Install the battery in the battery tray and connect the battery cables to the
battery.
NOTE: Use a battery rated at 12V-32AH
or more.
CAUTION:
Do not reverse polarity.
Serious damage to the generator and/or
battery may occur.
Battery
NOTE: Check. the electrolyte
level to be sure that it is between the marks on
the case. If the level is below the lower mark, remove the caps and add distilled
water to bring the electrolyte
level to the upper mark. The cells should be
equally
full.
38
Hide quick links:
Advertisement
Table of Contents
