2X4 Crossover - dbx DriveRack PA User Manual

Section 5

5.3 2X4 Crossover

32 DriveRack
Application Guide
Hardware
1.
Connect the outputs from the mixer to the inputs of the DriveRack
2. Connect the outputs of the DriveRack
3. Make sure that the mixer and power amps are turned off prior to powering up the
®
DriveRack PA.
Software
1. From Program mode, select factory program #F14 (MP212 2X4) as a template, or use the
Wizard to setup the specific program.
2. Once the program has been chosen, press the DATA wheel to load the program.
Left Low
Right Low
®
PA User Manual
®
PA and run to the selected speaker amplifier.
Left Right
Left High
Right High
Left High
Right High
MP412
Right
MP4718SP
Powered
DriveRack
®
.
MP412
MP4718S
Non-Powered
®
PA
®
®
®