Connect Down-Lead; Start Engine; Remove Down-Lead; Tow Truck - Chery RIICH 2 series User Manual

Connect Down-Lead

1. Properly stop the vehicle in order to
avoid them contacting each other.
2. Stop the engine and shut down all
unnecessary electrical equipment.
3. Connect the positive terminal (+) of
the low power battery to the positive
terminal (+) of the support battery via
the w ire A.
4. Connect one terminal of wire B to the
negative terminal (-) of the support
battery, the other terminal to the metal
part of the engine to be started.
Position the jumper wire in order to
avoid it contacting the motion parts in
the engine compartment.
5. M ake sure the jumper cable will not
interfere with the motion parts of
engine.

Start Engine

1. The engine of vehicle equipped with
the supp ort battery
properly high speed.
2. Start the engine of vehicle with the
low power battery. The vehicle shall
be started within one minute as soon
as possible.
3. Engines of two vehicles shall operate
for three minutes before the down-lead
is removed.
Emergency Procedures

Remove Down-Lead

•
Remove the down-lead B (-) first and
then down-lead A (+).

Tow Truck

There are trunk rings equipped at the front
and rear of the vehicle in order to fix the
tow cable.
During towing, slowly and smoothly drive
to avoid the tow trunk bounces. Towing
force too high may damage the vehicle.
operates at
During towing, the ignition
switch of vehicle to be towed shall
be placed at "ON" position to make
the steering wheel, turn indicator
lamp and stop
Because the engine extinguishes,
there is no brake boost and steering
boost. The required operating force
needs to be increased. So the power
of brake and steering shall be
increased correspondingly.
lamp working.
89