Table of Contents
Advertisement
Replace Bulbs
Unless the event is very urgent, the owner
is not allowed to replace bulbs of
headlamp
unit
individually.
replacement is necessary, please turn off
lamps and shut down ignition switch
before replacing any bulb.
DO NOT directly hold the bulb glass by
hand, otherwise the fingerprints remained
on the glass will be heated and volatilized
after the lamp lighting, and then deposit on
the surface of mirror to blacken the
reflector.
The same model of bulb must be used
when it is replaced. Please check the bulb
specification before installation.
Headlamp bulb:
12V 55W
Bulbs for turn indicator, reversing, rear
fog lamps:
12V 21W
Bulbs for license plate, position, turn
indicator and high-mount ed stop lamps:
12V 5W
Stop/ position lamp bulb:
12V 21W/ 5W
Front fog lamp bulb:
12V 55W
If
the
After the headlamp bulb is
replaced every time, calibrate the
headlamp. Chery's special service
station can offer you the service.
Headlamp
High Beam / Low Beam /
Position / Turn Indicator
Lamps)
Replace
the
according to the following steps if the
headlamp does not work due to damage.
1. Open the engine bonnet.
2. Unscrew
counterclockwise
shown in the figure.
3. Press the fasteners of bulb holder
downward with hand and make them
Unit
(Including
corresponding
bulbs
the
shields
of
bulbs
at
the positions
Emergency Procedures
passing through the location slot,
detach the fastener to both sides and
take out the bulb, notice the alignment
mark of bulb. Pull off the wiring
harness connector on the bulb. The
bulb of position lamp is inside the
shield of high beam/ dipped headlight.
Pull
out
the
bulb
connector together when it is replaced.
4. Notes: The surface of new bulb shall
not be touched by hand to prevent
effect on bulb brightness. The lighting
system is a safety component, please
make sure every detail of replacement
proper. Get to Chery's special service
station to have it repaired if necessary.
and
harness
79
Advertisement
Table of Contents
