Advertisement
Notice:
Do not use the ground lug on the XLR connector. Do not connect the shield conductor
to the ground lug or allow the shield conductor to come in contact with XLR outer casing. Grounding
the shield could cause a short circuit and erratic behavior.
Line Terminator:
last unit to avoid erratic behavior. A terminator is a 90 - 120 ohm 1/4 watt resistor which is connected
between pins 2 and 3 or a male XLR connector (DATA + and DATA -). This unit is inserted in the
female XLR connector of the last unit in your daisy chain to terminate the line. Terminators may be
purchased or you can make one by soldering a 90-120 ohm 1/4 watt resistor between pins two (2)
and three (3) of a male XLR Plug.
CAUTION:
The base of the fixture will get hot if it is operated for a long period of time. For optimum
performance, use a 30 min ON/ 10 min OFF duty cycle. Allow the unit to cool before attempting to
replace the bulb. Never open the unit when it is in use. Always disconnect the main power before ser-
vicing or replacing lamp. Refer all service issue to authorized American DJ dealer.
Lamp replacement:
before attempting any type of service. Please allow ample time for the
unit to cool down before handle the unit. With the power disconnected
unscrew the two (2) thumb screw located on the rear of the unit.
Gently pull out the lamp try. Remove and replace the lamp.
CAUTION:
Always replace with the exact same type lamp and fuse
unless otherwise specified by an authorized American DJ service
technician.
Customer Support:
support line, to provide set up help and to answer any question should you
encounter problems during your set up or initial operation. You may also
visit us on the web at www.americandj.com for any comments or sugges-
tions.
Service Hours Monday through Friday are 10:00 a.m. to 5:00 p.m. Pacific
Time.
Voice (800) 322-6337
Fax
(323) 582-2610
E-mail: support@americandj.com
DMX Traits:
Figure 12 list the traits for each DMX value. Use this charts to select your
desired color when using a DMX controller or programming.
Affordable Quality Lighting Products from
When longer runs of cable are used you may need to use a terminator on the
Disconnect the units main power supply
Remove Thumb Screws To Access Lamp
American DJ provides a toll free customer
American DJ
Los Angeles, CA. 90058 USA Page 6
®
Figure 11
WHITE
COLOR
CHANGE
SPEED
FLASH
SPEED
WHITE
MAGENTA
PINK
AMBER
GREEN
ORANGE
YELLOW
BLUE
LIGHT
GREEN
WHITE
BLACKOUT
Figure 12
255
254
160
159
86
78
72
60
54
44
37
26
18
9
0
Advertisement
