American DJ ROYAL 3D II User Instructions
  1. Manuals
  2. Brands
  3. American DJ Manuals
  4. Lighting Equipment
  5. ROYAL 3D II
  6. User instructions

American DJ ROYAL 3D II User Instructions

Five channel dmx intelligent, green and violet blue laser fixture
Hide thumbs
Table of Contents

Advertisement

Quick Links

Enlarged version
ROYAL 3D II
User Instructions
3/13
Royal 3D II
Unpacking:
Thank you for purchasing the Royal 3D II by ADJ Prod-
ucts, LLC. Every Royal 3D II has been thoroughly tested and has been
shipped in perfect operating condition. Carefully check the shipping
carton for damage that may have occurred during shipping. If the
carton appears to be damaged, carefully inspect your fixture for any
damage and be sure all equipment necessary to operate the unit has
arrived intact. In the event damage has been found or parts are miss-
ing, please contact our toll free customer support number for further
instructions. Please do not return this unit to your dealer without con-
tacting customer support first.
Introduction:
The Royal 3D II is an incredible five channel DMX intel-
ligent, green and violet blue laser fixture. The blue laser combined with
the green laser create amazing aerial effects on a ceiling or wall. The
Royal 3D II can operate as a stand alone fixture, or in a Master/Slave
configuration. The Royal 3D II has two operating modes; sound active
or controlled via DMX. This fixture is suitable for theaters, studios,
retail stores, and other similar locations. For best results use fog or
special effects smoke to enhance the beams projections.
Customer Support:
ADJ Products, LLC provides a toll free cus-
tomer support line, to provide set up help and to answer any question
should you encounter problems during your set up or initial operation.
You may also visit us on the web at www.adj.com for any comments
or suggestions. For service related issue please contact ADJ Products,
LLC. Service Hours are Monday through Friday 8:00 a.m. to 4:30 p.m.
Pacific Standard Time.
Voice:
(800) 322-6337
Fax:
(323) 582-2941
E-mail:
support@americandj.com
Warning!
To prevent or reduce the risk of electrical shock or fire, do
not expose this unit to rain or moisture.
Caution!
There are no user serviceable parts inside this unit. Do not
attempt any repairs yourself, doing so will void your manufactures war-
ranty. In the unlikely event your unit may require service please contact
ADJ customer support.
PLEASE recycle the shipping carton whenever possible.
ADJ Products, LLC - www.adj.com - Royal 3D II Instruction Manual Page 2
General Introduction

Advertisement

Table of Contents
loading

Related Manuals for American DJ ROYAL 3D II

Summary of Contents for American DJ ROYAL 3D II

  • Page 1 The blue laser combined with the green laser create amazing aerial effects on a ceiling or wall. The Royal 3D II can operate as a stand alone fixture, or in a Master/Slave configuration. The Royal 3D II has two operating modes; sound active or controlled via DMX.

  • Page 2: General Instructions

    Warranty Registration ventilation. Allow about 6” (15cm) between this device and a wall. The Royal 3D II carries a 90 day limited warranty. Please fill out the • Do not attempt to operate this unit, if it becomes damaged. enclosed warranty card to validate your purchase. All returned ser- •...

  • Page 3: Laser Warnings And Safety

    Always set up and install all laser effects so that all laser light is at least 3 meters (9.8 feet) above the floor on which people can stand. ADJ Products, LLC - www.adj.com - Royal 3D II Instruction Manual Page 5 ADJ Products, LLC - www.adj.com - Royal 3D II Instruction Manual Page 6...

  • Page 4: Laser Warning Labels

    Data Cable (DMX Cable) Requirements (For DMX and Master/Slave Operation): The Royal 3D II can be controlled via DMX-512 protocol. The Royal 3D II is a 5 channel DMX unit. The DMX address is set elec- tronically using the controls on the rear panel of 27mm the unit.
  • Page 5 120 Ohm 1/4 W) between PIN 2 (DMX-) Figure 4 and PIN 3 (DMX +) of the last fixture. ADJ Products, LLC - www.adj.com - Royal 3D II Instruction Manual Page 9 ADJ Products, LLC - www.adj.com - Royal 3D II Instruction Manual Page 10...

  • Page 6: System Menu

    3. When you have made your selection, press the ENTER, and then press and hold the MENU button for at least 3 seconds to confirm. ADJ Products, LLC - www.adj.com - Royal 3D II Instruction Manual Page 11 ADJ Products, LLC - www.adj.com - Royal 3D II Instruction Manual Page 12...
  • Page 7 1. Press the MENU button until “LED” is displayed, press ENTER. 2. The fixture will now reset. ADJ Products, LLC - www.adj.com - Royal 3D II Instruction Manual Page 13 ADJ Products, LLC - www.adj.com - Royal 3D II Instruction Manual Page 14...

  • Page 8: Operation

    1. The Royal 3D II is a five channel DMX fixture. See page 17 for 2. Set your Master unit to sound active mode. detailed description of the DMX values and traits.

  • Page 9: Fixture Cleaning

    Tapping on the microphone, quiet or high pitched sounds may 248 - 255 SOUND ACTIVE not activate the unit. ADJ Products, LLC - www.adj.com - Royal 3D II Instruction Manual Page 17 ADJ Products, LLC - www.adj.com - Royal 3D II Instruction Manual Page 18...

  • Page 10: Warranty

    1-year (365 day Limited Warranty) and batteries which have a 180 day limited warranty). Only the L.E.D.s carry a 3-year warranty Tel: +31 45 546 85 00 / Fax: +31 45 546 85 99 ADJ Products, LLC - www.adj.com - Royal 3D II Instruction Manual Page 19...

Table of Contents