Advertisement
ASSEMBLY INSTRUCTIONS CONT.
Step 4
Connect the air hose to water column tube by
inserting the rubber tube into the plastic nipple
located on the bottom of the tube (see figure 6).
Step 5
Figure seven (7) shows a properly inserted rubber
tube. Be sure that the rubber tube is seated com-
pletely unto the tube's plastic nipple.
Step 6
After properly inserting the rubber tube in the
the tubes plastic nipple, set the tube upright on
the water tube base. Align the screw hole on the
tube and the base to screw the base and the
tube together. Be sure to use the same brass
screws the were included with your fixture.
Step 7
Remove the water tube's protective white cover
located on the top of the water tube to replace the
tube assembly collar. Carefully replace the tube
collar by sliding it through the top of tube.
Affordable Quality Lighting Products from
Caution:
avoid damage
to your water
tube be sure not
to over tighten
the
securing
screws.!
American DJ
Los Angeles, CA. 90058 USA Page 3
®
Figure 6
Figure 7
To
Figure 8
Figure 9
Advertisement
