Advertisement
ASSEMBLY INSTRUCTIONS CONT.
Step 8
Secure the collar with the four (4) included black,
phillips screws.
Figure 10
PROPER WATER INSTALLATION
Due to the excessive weight of water filled in the tube, we suggest that you place the water column in
it's final position before filling the tube with water. This may avoid damage to the tube that may be
caused by the strain of the excessive weight caused by the water in the tube.
Once you have placed your water column in your desired position, fill the water tube only with dis-
tilled water to avoid water discoloration and oder. DO NOT FILL the tube pass the maximum fill
line level at the top of the tube, doing so may spurt water out caps breather hole. Use algae
tablets available where fish aquariums are sold is also highly recommended to avoid mildew and
oder.
Once you have filled the tube replace the protective white cap. The cap has a breather hole punched
out in the center of it, be sure never to restrict this hole to avoid possible damage to the unit's air
pump.
If it becomes necessary to move your water column after it has been filled with water, be sure not to
lift the assembly by the tube or you may crack the tube. Always move your water column by grasping
the base of the unit.
POWER SUPPLY:
Before plugging your unit in be sure the voltage in your area matches the required voltage for your
unit. The DMX Operator™ require a DC 9v 200mA power supply.
The DMX Operator™ is available in a 115v and 230v version. Because line voltage may vary from
venue to venue, you should be sure to plug your power supply into a matching wall outlet before
attempting to operate you controller.
OPERATING INSTRUCTIONS
Stand Alone (Sound Active):
This function allows you to operate an individual fixture to sound without the use of a controller. In
this mode the unit scroll through its' internal programs to the beat of the music. When there is no
sound source for a period of ten (10) seconds the fixture will automatically go into blackout mode.
When there is no sound source for more than 30 seconds the fixture will automatically shut down the
lamp output to prolong lamp life. The unit will continue to operate normally once a sound source has
been reintroduced.
To run a fixture in this mode: Be sure the unit is powered down. Set dip switch number 10 to the on
position and be sure that all others dip switches are set to the off position. Turn the power on. The
unit will take about 10 seconds to reset and then begin to react to low frequencies of a sound source.
Master/Slave: This function allows you to connect up to eight (8) units together and run them to
internal programs without the use of an external controller.
American DJ
Affordable Quality Lighting Products from
Los Angeles, CA. 90058 USA Page 4
®
Advertisement
