Fiat Linea Owner's Handbook Manual page 70

"Smart washing" function
Pull the stalk towards the steering wheel
(unstable position) to operate the wind-
screen washer.
Keeping the stalk pulled for more than half
a second, with just one movement it is
possible to operate the washer jet and the
wiper at the same time.
The wiper stops working three strokes af-
ter releasing the stalk.
A further stroke after 6 seconds com-
pletes the wiping operation.
RAIN SENSOR
(where provided)
The rain sensor is located behind the dri-
ving mirror in contact with the windscreen
and has the purpose of automatically ad-
just, during the intermittent operation, the
frequency of the windscreen wiper
strokes as to the rain intensity.
IMPORTANT Keep clean the glass in the
sensor area.
Activation
Move the right-hand stalk knurled ring to
≤ fig. 46.
The activation of the rain sensor is sig-
nalled by a control acquisition "stroke".
Through the set up menu it is possible to
increase the sensitivity of the rain sensor.
The increase of the sensitivity of the rain
sensor is signalled by a control and acqui-
sition "stroke".
Operating the windscreen washer with
the rain sensor activated the normal wash-
ing cycle is performed at the end of which
the rain sensor resumes its normal auto-
matic function.
Deactivation
Change the stalk knurled ring position
from ≤ fig. 46 or turn the ignition key
to STOP.
At the next start-up (key at MAR), the
sensor will not be reactivated even if the
knurled ring is at ≤ fig. 46. To reacti-
vate the sensor, move the ring from po-
sition ≤ to any other position and then
return it to position ≤ .
Rain sensor activation will be indicated by
at least one wiper "stroke" even if the
windscreen is dry.
The rain sensor is able to recognize and
automatically adjust itself in the presence
of the following particular conditions:
❒ presence of dirt on the controlled sur-
face (salt, dirt, etc.);
❒ difference between day and night.
IMPORTANT Streaks of water may cause
unnecessary blade moving.
69