Seat Belts - Fiat Linea Owner's Handbook Manual

SEAT BELTS

USING THE SEAT BELTS fig. 1
The belt should be worn keeping the chest
straight and rested against the seat back.
To fasten the seat belts, take hold the
tongue A and insert it into the buckle B,
until hearing the locking click.
At removal, if it jams, let it rewind for a
short stretch, then pull it out again with-
out jerking.
Press button C to release the belt. Ac-
company the belt while it is being re-
wound to prevent twisting.
Through the reel, the belt automatically
adapts to the body of the passenger wear-
ing it, allowing freedom of movement.
The reel may lock when the car is parked
on a steep slope: this is perfectly normal.
Furthermore, the reel mechanism locks
the belt if it is pulled and in the event of
sudden braking, collisions and on high
speed bends.
The rear seat is fitted with inertial seat
belts with three anchor points and reel.
104
fig. 1
fig. 2
WARNING
Never press button C-fig. 1
when travelling.
The rear seat belts must be used as shown
in the diagram in fig. 2.
F0R0150m fig. 3
ADJUSTING THE FRONT SEAT
BELT HEIGHT
Always adjust the seat belt height to the
passenger's body: this precaution may
considerably reduce the risk of injury in
the event of a collision.
Correct regulation is obtained when the
belt passes approximately half way be-
tween the shoulder and the neck.
F0R0088m
To adjust, move the grip A-fig. 3 of the
locking mechanism either up or down and
at the same time move the ring B-fig. 3
to the most suitable of the allowed posi-
tions.
B
A
F0R0151m