Seat Belts - Fiat TIPO 5DOOR 2023 Owner's Handbook Manual

correct way to guarantee the maximum
possible safety level for the driver and
the passengers.
For the description of the head restraint
adjustment see the "Head restraints"
paragraph in the "Knowing your car"
chapter.

SEAT BELTS

All vehicle seats are equipped with seat
belts with three anchor points and a
retractor.
The reel mechanism operates locking
the belt in the event of sharp braking
or strong deceleration due to an
impact. This allows the belt strap to
slide freely and to adapt to the body
of the occupant. In the event of an
accident, the belt will lock reducing the
risk of impact inside the passenger
compartment and of being projected
outside the car.
The driver is responsible for respecting,
and ensuring that all the other
occupants of the vehicle also respect,
the local laws in force in relation to the
use of the seat belts.
Always fasten the seat belts before
setting off.
USING THE SEAT BELTS
The seat belt should be worn keeping
the chest straight and rested against
the backrest.
To fasten the seat belts, hold fastening
tongue (1) fig. 125 and insert it into
buckle (2), until it clicks into place.
125
On removal of the belt, if it jams, let it
rewind for a short stretch, then pull it
out again without jerking.
To unfasten the seat belts, press
button (3) fig. 125 and guide the seat
belt with your hand while it is rewinding,
to prevent it from twisting.
86) 87)
The retractor may lock when the car
is parked on a steep slope: this is
perfectly normal. Furthermore, the
reel mechanism locks the belt if it is
pulled sharply or in the event of sudden
braking, collisions and high-speed
bends.
Once seated, wear the rear seat belts
as shown in fig. 126.
126
ADJUSTING THE FRONT
SEAT BELT HEIGHT
06056J0004EM
(for versions/markets, where provided)
88) 89)
Four different adjustments in height are
possible.
To adjust the window height, from the
top downwards, press the button
(1) fig. 127 and slide the handle
downwards.
To carry out window height adjustment,
from the top to the bottom, the
grip must be slid (without pressing
anything).
P103FI84-000-000
109