Calibrating The Expression Pedal - DigiTech Whammy DT Owner's Manual

Calibrating the Expression Pedal

In the unlikely event that the expression pedal does not respond properly or that the note does
not bend or return to the correct pitch, it may need to be re-calibrated. The following steps outline
the procedure for expression pedal re-calibration:
1. Disconnect the power from the Whammy pedal.
2. Press and hold the
enables MIDI and Calibration Setup. One of the
indicating the currently selected MIDI channel.
3. Rock the
Expression Pedal
. When you press the footswitch, the
Footswitch
light Red and then change to Green indicating Expression Pedal calibration is now enabled.
If the
DROP TUNE Effect Status LED
rocked fully forward and press the
4. Rock the
Expression Pedal
times. The
SHIFT UP LEDs
is rocked indicating the pedal is calibrating.
5. When finished, press the
Calibration set up and return to normal operation.
This completes the expression pedal calibration procedure.
Page 16
WHAMMY Effect Footswitch
fully forward (toe down) and then press the
stays Red, make sure the
DROP TUNE Footswitch
fully back (toe up) and fully forward (toe down) at least two
will light back and forth (from 1 to OCT + DRY) as the pedal
WHAMMY Effect Footswitch
while reconnecting the power. This
WHAMMY Effect LEDs
DROP TUNE Effect Status LED
Expression Pedal
until the LED lights Green.
again to exit the MIDI and
will begin to flash
DROP TUNE
will first
is