Table of Contents
Advertisement
Connect data modules
2. When the ANS = AUTO? prompt appears, press the ENTER/YES button
for most applications.
Push the button indicated by the arrow ( )
Configuring the RS-232 interface of the 7400D
From the front panel, you can set each pin of the RS-232 cable to meet the needs
of specific applications, though in most cases, the settings below should work.
1. When the SET CI LEAD? prompt appears, press the ENTER/YES button.
Push the button indicated by the arrow ( )
2. Press the NEXT/NO button until you see the CI = correctSetting? or
correctSetting? prompt. Then press the ENTER/YES button.
Push the button indicated by the arrow ( )
3. When the CONTINUE? prompt appears, press the ENTER/YES button.
Push the button indicated by the arrow ( )
4. When the SET CH LEAD? prompt appears, press the ENTER/YES button.
Push the button indicated by the arrow ( )
555-233-116
ANS = AUTO?
SET CI LEAD?
CI = correctSetting?
CONTINUE?
SET CH LEAD?
DATA
NEXT/NO
BACK ENTER/YES
DATA
NEXT/NO
BACK ENTER/YES
DATA
NEXT/NO
BACK ENTER/YES
DATA
NEXT/NO
BACK ENTER/YES
DATA
NEXT/NO
BACK ENTER/YES
Issue 4 October 2002
CI
->
87
Advertisement
Table of Contents
