Table of Contents
Advertisement
Connecting a CDR device
The CDR System Parameters screen appears.
change system-parameters cdr
Node Number (Local PBX ID):
Primary Output Format: printer
Secondary Output Format:
Use ISDN Layouts? n
Use Enhanced Formats? n
Modified Circuit ID Display? n
Record Outgoing Calls Only? y
Suppress CDR for Ineffective Call Attempts? y
Disconnect Information in Place of FRL? n
Force Entry of Acct Code for Calls Marked on Toll Analysis Form? n
Record Called Vector Directory Number Instead of Group or Member? n
Record Called Agent Login ID Instead of Group or Member? n
Inc Trk Call Splitting? n
Record Non-Call-Assoc TSC? n
Record Call-Assoc TSC? n
Privacy - Digits to Hide: 0
2. In the Primary Output Endpoint field, type CDR1. If you use a
secondary output device, and that device is also connected through TCP/
IP, type CDR2 in the Secondary Output Endpoint field.
3. Press
Testing the switch-to-adjunct link
You can use the test, status, busyout and release commands for to find and
correct problems with CDR links. For more information about these commands,
see the Maintenance manual for your switch.
status cdr-link
Primary
Link State: up
Maintenance Busy? no
You should also work with the vendor to test the link from the call accounting end.
If you are installing the INTUITY Lodging Call Accounting, work with the Homisco
technician to test the link.
If a link does not come up immediately, try using the busyout cdr-link and release
cdr-link commands.
555-233-116
CDR SYSTEM PARAMETERS
Condition Code 'T' for Redirected Calls? n
Calls to Hunt Group - Record: member-ext
Digits to Record for Outgoing Calls: dialed
to save your changes.
ENTER
CDR LINK STATUS
CDR Date Format: month/day
Primary Output Endpoint: CDR1
EIA Device Bit Rate: 9600
Remove # From Called Number? n
Intra-switch CDR? n
CDR Call Splitting? y
Attendant Call Recording? y
Interworking Feat-flag? n
CDR Account Code Length: 4
Secondary
extension not administered
Issue 4 October 2002
Page
1 of
1
175
Advertisement
Table of Contents
