Wireless Phone Status Messages - Avaya IP Office Installation And Configuration Manual

Wireless Installation and Configuration Guide

Wireless Phone Status Messages

Wireless phone status messages provide information about the wireless phone's communication with the
access point and host phone system. The following table summarizes the status messages, in
alphabetical order.
Message
3 chirps
ASSERTxxx.c
Line yyy
Bad Config
Bad ESSID
Charging...
Charge Complete
Checking Code
Checking DHCP IP
CRC Code Error
Code Mismatch!
Wireless Installation and Configuration Guide
IP Office
Description
The wireless phone is not able
to communicate with the best
access point, probably
because that access point has
no bandwidth available.
The wireless phone has
detected a fault from which it
cannot recover.
Some needed configuration
parameter has not been set.
The wireless phone is
configured for "static ESSID"
(as opposed to "Learn once"
or "Learn always" and no ESS
ID has been entered.
The wireless phone is
charging in the desktop
charger.
The wireless phone is now
fully charged.
The wireless phone is
contacting the TFTP Server to
determine if it has a newer
version of software that should
be downloaded.
The wireless phone is
retrieving DHCP information
from the DHCP server.
The software which has been
TFTP downloaded has a bad
redundancy code check.
The software loaded into the
wireless phone is incorrect for
this model phone
Action
None. This is only a warning, the
call will handoff to the best access
point once it becomes available.
Record the error code so it can be
reported. Turn the wireless phone
off then on again. If error persists,
try registering a different wireless
phone to the phone port. If error
still persists, contact Technical
Support and repeat the error.
Check all required wireless phone
configuration parameters for valid
settings.
Enter an ESSID in the
configuration settings or change to
one of the "Learn" modes.
No action needed.
No action needed.
None, this message should only
last for approximately one second.
If message remains displayed,
power off and contact customer
support for a replacement phone.
None. This is information only.
Try the download again, it is
possible the software was
corrupted during download. If the
error repeats, check that the
download image on the TFTP
server is not corrupted.
Replace the software image on
the TFTP server with software that
is correct for the phone model.
[15-601082] Issue [1] (1 June 2006)
Page 62