Cisco CRS-1 - Carrier Routing System Router Configuration Manual page 203

Configuring Software Authentication Manager on Cisco IOS XR Software
DETAILED STEPS
Command or Action
Step 1
configure
Example:
RP/0/RP0/CPU0:router# configure
Step 2
sam prompt-interval time-interval {proceed |
terminate}
Example:
RP/0/RP0/CPU0:router(config)# sam
prompt-interval 25 {proceed | terminate}
Step 3
end
or
commit
Example:
RP/0/RP0/CPU0:router(config-sam-prompt-interval
)# end
or
RP/0/RP0/CPU0:router(config-sam-prompt-interval
)# commit
OL-20382-01
How to set up a Prompt Interval for the Software Authentication Manager
Purpose
Enters global configuration mode.
Sets the prompt interval in seconds, after which the SAM
either proceeds or terminates the interval. The Prompt
interval ranges from 0 to 300 seconds.
If the user responds, SAM considers it as a 'Yes' and
proceeds with the next action. If the user does not respond,
SAM considers it as a 'No' and terminates the action. The
default time for which SAM waits is 10 seconds.
Saves configuration changes.
When you issue the end command, the system prompts
•
you to commit changes:
Uncommitted changes found, commit them before
exiting (yes/no/cancel)?
[cancel]:
Entering yes saves configuration changes to the
–
running configuration file, exits the configuration
session, and returns the router to EXEC mode.
– Entering no exits the configuration session and
returns the router to EXEC mode without
committing the configuration changes.
Entering cancel leaves the router in the current
–
configuration session without exiting or
committing the configuration changes.
Use the commit command to save the configuration
•
changes to the running configuration file and remain
within the configuration session.
Cisco IOS XR System Security Configuration Guide for the Cisco CRS-1 Router
SC-197