Interruption Of Print By Temperature Control - Konica Minolta KIP 9900 User Manual

3. 5 Interruption of Print by Temperature
Control
Sometimes the KIP 9900 may not start printing soon even if print/copy job has been submitted
from the outer device. After having some interval, then the KIP 9900 will start printing in such case.
Or the KIP 9900 may suddenly stop printing in the middle of large volume of continuous printing.
After having some interval similarly, the KIP 9900 will restart printing.
These 2 operations are not error but a correct operation to adjust the temperature of Fuser. The
Ready Indicator flashes in the interval, and the KIP 9900 is changing the temperature to
appropriate level during this period. This operation will possibly occur in these 3 cases.
•
When media type is changed
•
When making a large volume of continuous printing
•
When in a very cold environment
Just wait until the KIP 9900 finishes adjusting the temperature to proper level. It automatically
starts printing when adjustment is finished.
WIRE CLEAN EXP- CLEAN
Ready Indicator flashes.
NOTE
If the above mentioned cases occur very frequently, check the followings.
•
Printing media (More temperature is lost if thicker media is used, so the interval may be
required for recovering enough temperature.)
•
Input voltage (If the input voltage is lower than requirement, the fuser unit may not be
able to keep required temperature. Interval for recovering the temperature will be
required.)
•
Temperature of room air (If the room air is very cold, the fuser unit may not be able to
keep required temperature. Interval for recovering the temperature will be required.)
PAPER DECK
MF
D1
1 2 3 4
D2
SELECT CUT
D3
3-32
EXIT
PF
COPY DENSITY MENU
D4
Chapter 3 Error Correction & Maintenance
ENTER ONLINE