Right Front Housing / Left Front Housing - Epson R260 - Stylus Photo Color Inkjet Printer Service Manual

EPSON Stylus Photo R260/R265/R270, R360/R380/R390
Wipe off any ink on the joint portion of the Waste Ink Tube
before reconnecting the tube. Ink on the joint portion makes
the tube likely to get disconnected.
Insert the Waste Ink Tube until its leading edge reaches the
point where the shaft of the Waste Ink Tray starts to widen as
shown below.
Waste Ink Tray
Figure 4-32. Cautions of installing the Waste Ink Tray
Tighten the screws in the order given in Fig.4-30.
Disassembly/Assembly

4.2.8 Right Front Housing / Left Front Housing

Edge of the Tube
Tray Shaft
Waste Ink Tube
Removing Exterior Parts/Components
Parts/Components need to be removed in advance
Paper Support / Printer Cover / Front Cover / Right Housing / Left Housing / USB
Housing / Upper Housing / Panel Unit / EMI Frame / Waste Ink Tray
Removal procedure
Take extra care to avoid injury from sharp metal edges. Before
starting, see the page given below to check the dangerous edges.
• "4.1.8 Sharp Metal Edges (Danger!)" (p.62)
1. Disengage the two tabs at (1) portion (inside the Front Housing) by lightly
pushing down the tip of the tabs. First disengage the lower tab and then
disengage the upper one.
2. Pull the Right Front Housing toward you to remove it.
3. Disengage the two tabs at (2) portion in the same manner, and remove the Left
Front Housing
Lower Tab
2
Upper Tab
Tab position of Left Front Housing
Left Front Housing
Figure 4-33. Removing Left/Right Front Housings (1)
Revision B
1
Tab position of Right Front Housing
Right Front Housing
72