Housing (Right/Left/Frame), Stacker Assy. Removal - Epson C63, C64, C83, C84 Service Manual

EPSON Stylus C63/64/83/84

1.3.1 Housing (Right/Left/Frame), Stacker Assy. removal

o
External view
2
1
3 4
5
Housing (Left)
Insert metal scale from this slit, and
release one hook of I/F cover.
This hook is not only the right
side but also the left side.
Damper
Housing (Frame)
Front side
Stacker assy.
Figure 1-2. Housing (Right/Left/Frame) and Stacker assy. removal
o
Part/Unit that should be removed before removing Housing (Right/Left/
Frame) or Stacker assy..
Non
Disassembly and Assembly
1
2
3
4
5
Housing (Right)
Backside
This marking is the hook that should
be removed/installed.
This marking is more careful hooks
in assembling/disassembling
This marking is the hook portion for
1
Housing cover (Right/Left) and the
order of assembling.
o
Removal procedure
[Housing (Right/Left/Frame) removal]
1) Releasing five hooks by hand/precision screwdriver (-), and remove Housing
(Right).
2) Release one hook of I/F cover by inserting metal scale vertically from the slit on
bottom of Housing (Left), and remove I/F cover.
3) Releasing five hooks by hand/precision screwdriver (-), and remove Housing
(Left)
4) Release five hooks by hand/precision screwdriver (-), and remove Housing
(Frame).
[Stacker assy. removal]
1) Push cut-out portion of Stacker Assy. (left side) by precision screwdriver (-),
and pull Stacker assy. to the front side of the printer.
o
Do not damage hooks by hand/precision screwdriver (-) in
removing Housing (Right/Left) & Stacker assy..
o
Do not tilt the printer too much when Housing (Right/Left/
Frame) is removed by hand/precision screwdriver (-). This is
because ink may possible flow if the cap is not covered by
the Print head. (CR is out of the home position)
o
When assembling Housing (Right/Left/Frame) or Stacker
assy. to printer mechanism,
n
n
n
n
Disassembly
Hook five ribs for securing Housing cover (Right/Left)
to Housing (Right/Left) in the order indicated in the
figure.
Make sure that hooks/protrusions of Housing (Right/
Left/Frame), Stacker assy., SW bottom and Panel board
is correctly fixed to Housing (Frame/Lower).
Make sure that there is not the clearance between
Housing (Right/Left/Frame) and Housing (Lower).
Make sure that damper for Stacker assy. is correctly
installed to the Housing (Lower).
Revision A
13