NETGEAR MBR1310 User Manual page 9

NETGEAR Mobile Broadband 11n Wireless Router MBR1310
Button/LED Activity
Power/Test Solid green
Solid amber
Off
Restore Factory Settings
button
Internet Solid green
Solid red
Blinking green
Blinking green and red
Off
WiFi Solid blue
Blinking blue
Off
ACT Solid green
Blinking
Off
WAN Solid green
Blinking
Off
2G/3G Solid blue
Solid green
Off
Signal Quality Solid blue
Solid green
Solid amber
Off
Description
The router is powered on and operating normally.
POST (power-on self-test) in progress.
Power is not supplied to the router.
Press the Restore Factory Settings button for 6 seconds. The
Power LED lights briefly. When the button is released, the LED
blinks red three times and then turns green as the router resets to
the factory defaults.
There is an Internet session.
There is no Internet connection.
Data is being transmitted over the Internet connection.
Traffic meter limit has been reached.
No Internet connection detected or device in bridge mode.
The WiFi local port is initialized.
Data is being transmitted or received over the WiFi link.
The wireless access point is turned off.
The local Ethernet ports have detected wired links with computers.
Data is being transmitted or received.
No link is detected on these ports.
The Ethernet WAN port has detected an active link.
Data is being transmitted or received.
No link is detected on this port.
The router is in 3G+ coverage.
The router is in 2G coverage.
No mobile broadband coverage is detected.
Excellent mobile broadband coverage detected.
Good mobile broadband coverage detected.
Marginal mobile broadband coverage detected.
No mobile broadband coverage detected.
Connecting to the Internet
9