Table of Contents
Advertisement
LaCie 2big Quadra
User Manual
3.4.2. Formatting for Windows Users
The process of formatting a drive on a computer running Win-
dows 2000, Windows XP or Windows Vista consists of two steps:
(1) installing a signature on the drive, and (2) formatting the
drive. These steps will erase anything that is on the disk.
CAUTION:
Following these steps will erase everything from
the 2big. If you have information that you want to protect or
continue to use, back up this information onto another medium
before performing these steps.
TECHNICAL NOTE:
Windows XP 32-bit and Windows 2000: These operating
systems will not recognize volumes greater than 2TB in size.
Windows XP x64 and Windows Vista Enterprise/Ultimate
(32- and 64-bit versions): These operating systems will rec-
ognize volumes greater than 2TB in size, but the disks must be
converted to the GPT file system before partitions greater than
2TB can be created.
1. Connect the drive to the computer via the interface port.
2. Right-click My Computer and select Manage.
3. From the "Computer Management" window, select Disk
Management (located below the Storage group). See Fig.
3.4.2-A (screens may differ slightly depending on the sys-
tem).
TECHNICAL NOTE:
If the 2big Quadra is in Mixed mode,
there will be two partitions on the disk.
4. If the "Initialize and Convert Disk Wizard" window appears,
click Cancel.
5. Windows will list the Hard Disks that are installed on the
system. Locate the drive that is represented by the
Right-click the icon and select Initialize.
TECHNICAL NOTE:
If the 2big is in Mixed mode, format
each partition separately.
6. Windows XP x64 and Windows Vista Enterprise/Ultimate
users only:
Right-click the disk and click Convert to GPT.
7. In the box to the right that says Unallocated, right-click and
select New Partition...
•
DESIGN BY NEIL POULTON
icon.
Figure 3.4.2-A
Setup
page 22
Advertisement
Table of Contents
Troubleshooting
