Agilent Technologies U1242A User's Manual And Service Manual page 41

Table 3-9 Available setting options in Setup mode
Menu item
Setup
Description
rHd
Trigger hold
SCA
Percentage scale
FrE
Minimum frequency
can be measured
bEP
Frequency of beep
sound
tnP
Thermocouple
Log
Data logging (for
U1242A)
APF
Auto power off
Lit
Backlight timer
dAC
Default AC or DC for
voltage and current
measurements
rSt
Reset
U1241A/U1242A User's and Service Guide
Selection
OFF
100–1000
0–20 mA,
4–20 mA
0.5 Hz, 1 Hz,
2 Hz, 5 Hz
2400 Hz,
1200 Hz,
600 Hz, 300 Hz
OFF
tYPE
[1]
tYPE
tYPE mV
Hand
1–9999
1–99 m
[1]
OFF
1–99
OFF
dC, AC
dFAU
Available setting options
Description
Enables Data Hold (manual trigger)
Sets variation count that determines Refresh
Hold (auto trigger)
Sets % scale readout for 0 to 20 mA or 4 to 20 mA
Sets the minimum frequency that can be mea-
sured in AC measurement mode
Sets frequency of beep sound of the meter
Disables beep sound of meter
Sets thermocouple type to K-type
Sets thermocouple type to J-type (for U1242A)
Sets 100 mV measurement for T1 input
Enables manual data logging
Sets interval for automatic data logging from 1 to
9999 seconds. Press
digit to be adjusted.
Sets timer in minutes for auto power off
Disables auto power off
Sets timer in seconds for auto turn-off for back-
light display
Disables auto turn-off for backlight display
Defines the preferred setup of AC or DC for volt-
age and current measurement once meter is
turned on.
Resets the meter to the factory settings by press-
ing and holding for more than 1 second.
A beep sound indicates the reset is being done.
Default Setting Configurations
Default factory
to toggle through the
3
setting
500
4–20 mA
0.5 Hz
2400 Hz
tYPE K
Hand
15 m
15
dC
dFAU
27