Table of Contents
Advertisement
5.4.4
JMicron
®
The JMicron
Serial ATA controller allows you to configure RAID 0, RAID 1 and
JBOD sets on the external Serial ATA hard disk drives.
Before creating a RAID set
Prepare the following items:
1.
Two SATA HDDs, preferably with the same model and capacity.
2.
A write-enabled floppy disk (Windows XP). A write-enabled floppy disk or a
USB flash disk drive (Windows Vista)
®
3.
Microsoft
Windows
4.
Motherboard support CD with JMB363 driver
Complete the following steps before you create a RAID set:
1.
Install the two external Serial ATA hard disk drives on your system.
2.
Set the Controller Mode item in the BIOS to [RAID]. See section 4.4.4
Onboard Device Configuration for details.
Advanced
Onboard Devices Configuration
Serial Port1 Address
J-Micron eSATA/PATA Controller [Enabled]
Controller Mode
Front Panel Support Type
Onboard 1394
Onboard LAN
Onboard LAN Boot ROM
PCI Express x1
Primary Display Adapter
v02.61 (C)Copyright 1985-2007, American Megatrends, Inc.
3.
Enter the JMB363 RAID BIOS utility to set up your RAID configuration.
4.
Create a JMB363 RAID driver disk for Windows
5.5 Creating a RAID driver disk for details.
5.
Install the JMB363 driver after the Windows
Always install the JMB363 driver before creating RAID sets.
ASUS Z7S WS
®
RAID Configuration
®
OS installation disk (Windows XP)
BIOS SETUP UTILITY
[3F8/IRQ4]
[IDE]
[AC97]
[Enabled]
[Enabled]
[Disabled]
[Auto]
[PCI-E]
Allows BIOS to Select
S e r i a l P o r t 1 B a s e
Addresses.
Select Screen
Select Item
+- Change Option
F1 General Help
F10 Save and Exit
ESC Exit
®
OS installation. See section
®
OS had been installed.
5-33
Advertisement
Table of Contents
