Table of Contents
Advertisement
CONNECTION DIAGRAM
As you hook up
the
SR18,
the
volume control on
your power amp
and
the
SR18
should be all the
way down, and
power
to
both
units should be
off.
1.
Plug ¼" TS cables from the MAIN OUTPUTS to an amplifier, mixer, or speaker system. For mono
sound, you can connect only one output.
2.
Alternatively, you can connect a pair of ¼" TRS headphones to the PHONES OUTPUT to practice
quietly.
3.
Connect your instrument to the INSTRUMENT INPUT.
4.
Connect a MIDI device, such as a sampler or sound module, to the MIDI OUT of the SR18.
5.
Connect a MIDI device, such as a percussion controller, to the MIDI IN of the SR18.
6.
If you have ¼" TS footswitches, connect them to the START / STOP and COUNT / A / B / FILL
jacks.
7.
Plug the included power adapter (12V DC 500mA) into the adapter jack and the adapter into a
power source. Alternatively, you may choose to power the unit by inserting 6 AA batteries into the
bottom compartment.
8.
Press the POWER switch to turn on the unit.
9.
Tap the pads to hear sounds. You can switch among the three different sound categories for the
pads by pressing the corresponding button (DRUMS, PERC, BASS).
10.
Adjust the volume control on the rear panel to a suitable listening level.
Note that you may also connect the stereo Aux output to a speaker system or amplifier, using a ¼" TRS cable. The
SR-18 can be setup to output sounds through the Main or Aux connections (Main by default). See "Creating and
Editing Drum Sets / Page 12: Output" for more information.
8
Advertisement
Table of Contents
