Table of Contents
Advertisement
SENDING MIDI SYSEX SONG AND PATTERN DATA TO THE SR18
If you wish to load Pattern and Song data back into the SR18, please follow the instructions
below. Please note that this operation will erase any Song and Pattern data which exists on the
SR18!
1.
Connect a 5-pin MIDI cable from your MIDI SysEx device to the SR18's MIDI IN.
2.
Turn off the SR18.
3.
Hold down the SAVE / COPY button.
4.
Turn on the SR18 while holding down the
SAVE / COPY button.
5.
After a few seconds, you should see the
screen displayed on the right. The SR18 is
ready to receive data.
6.
Now transfer the MIDI system exclusive data
into the SR18.
device's documentation for information on
transferring MIDI SysEx.
7.
Once the transfer is complete, turn off the
SR18 and then turn it back on.
Refer to your MIDI SysEx
53
Advertisement
Table of Contents
