Table of Contents
Advertisement
Setting a Password
Follow these steps:
1. Use the
(Supervisor or User) and press the Enter key. The password box
appears.
:
2. Type a password. The password may consist of up to seven
characters (A-Z, a-z, 0-9).
Note: Important: Be very careful when typing your password because
the characters do not appear on the screen.
3. Press Enter. Retype the password to verify your first entry and press
Enter.
After setting the password, the computer automatically sets the
chosen password parameter to Enabled.
4. Press Esc to go to the Exit menu.
5. Press Save Change & Exit to save the password and exit the Setup
Utility.
To change a password, follow the same steps used to set a password.
Removing a Password
Should you want to remove a password, do the following:
1. Use the
(Supervisor or User) and press the Enter key. The password box
appears
:
2. Enter your current password in the first parameter and then press
Enter.
3. Press Enter twice without entering anything in the next two password
Chapter 2
and
keys to highlight a Set Password parameter
and
keys to highlight a Set Password parameter
27
Advertisement
Table of Contents
