Table of Contents
Advertisement
10. Press the drive assembly loops toward each other; then, carefully slide the
11. See "Power and signal cables for internal drives" on page 69 and the Problem
12. Close the drive bay EMC shield.
13. Close the bezel.
If you have other options to install or remove, do so now; otherwise, go to
"Completing the installation" on page 97.
The simple-swap-drive backplate controls the IDs for the internal simple-swap drive
bays. The following table lists the IDs for the hard disk drives and backplate that
are connected to simple-swap models.
68
System x3400 M2 Types 7836 and 7837: Installation and User's Guide
8. Touch the static-protective package that contains the drive to any unpainted
metal surface on the server; then, remove the drive from the package and
place it on a static-protective surface.
9. Align the drive assembly with the guide rails in the bay (the connector end of
the drive goes in first).
drive assembly into the drive bay until it stops and release the loops.
Note: Do not release the loops on the drive assembly until it is completely
seated.
Determination and Service Guide for cabling information, if needed.
Table 12. IDs for the 3.5-inch simple-swap drive models
Drive bay number
Drive bay 4
Drive bay 5
Drive bay 6
Drive bay 7
ID
0
1
2
3
Advertisement
Table of Contents
