Table of Contents
Advertisement
12. Remove the blue optical drive rails from the inside of the drive bay in which
13. If you are installing a 5.25-in. drive in bay 2, push the drive into the bay until it
14. Connect power and signal cables to the drive and the connectors on the
15. Route the signal cable through the plastic slot on the bottom of the chassis
58
System x3400 M2 Types 7836 and 7837: Installation and User's Guide
Note: You might find it easier to install the new drive from the front and then
attach the cables.
you want to install the drive. Align the holes on the blue optical drive rails with
the pins on the side of the drive and snap the optical drive rails onto the drive.
locks into place. If you are installing a 3.5-in. drive in bay 2, attach the 5.25-in.
conversion kit and push the drive into the drive bay.
system board.
underneath the fan cage assembly so that it does not block the airflow to the
rear of the drives as shown in the following illustration:
Advertisement
Table of Contents
