Ethernet Connection - Epson Stylus 1500 Setup Information Manual

4. Attach one end of a LocalTalk cable to the connector box on
the printer and the other end of the cable to the connector
box on your Macintosh.
Note:
If you are connecting to a LocalTalk network, you may attach the
other end of the cable to any available port on any connector box
that is part of the network.
5. Make sure the printer's network interface mode is on. See
page 1-26 for instructions.
For more information about creating a LocalTalk network, see
the guide that comes with the LocalTalk Locking Connector Kit.

Ethernet Connection

If you installed an Ethernet board in your printer, follow these
steps:
1. Make sure both the printer and computer are turned off.
For 10BASE2 coaxial connections, continue with step 2. For
10BASE-T connections, skip to step 4.
2. Attach the T-connector supplied with the board to the
10BASE2 connector on the board.
3. Connect the coaxial cable to one node of the T-connector. If
you are not connecting any other devices, or the printer is
the last device in a daisy chain, attach a 50-ohm terminator
to the other node of the T-connector. If the printer is not the
last device in a daisy chain, connect another network cable
to the other node of the T-connector.
4. Connect one end of the 10BASE-T cable to the interface board.
5. Connect the other end of the cable to a transceiver.
Setting Up the Printer
1-25