Installing The Localtalk Or Ethernet Board - Epson Stylus 1500 Setup Information Manual

Installing the LocalTalk or Ethernet Board

Follow the steps below to install a LocalTalk or Ethernet board:
1. Turn off the printer.
2. Unplug the printer's power cord from the electrical outlet.
Caution:
c
Do not install or remove an interface board when the
printer is connected to the electrical outlet; this may
damage your printer or computer.
3. Remove the two screws securing the shield plate to the
optional interface slot; then lift off the plate as shown
below. Store the plate in case you later remove the interface
board.
4. Be sure to set any switches and jumpers on the interface
board. See the board's manual for details. If your interface
board has a jumper labelled JG, make sure that you set it to
on, or the board will not work properly.
Setting Up the Printer
1-23